Nissan E6210-CF40B ABSORBER Kit-Shock,Rear

You can Select Your Vehicle to check if E6210-CF40B fits your vehicle.

To remove the front shock absorber/coil spring assemblies, follow these steps: Loosen the front wheel lug nuts. If it's an AWD model, also loosen the driveaxle/hub nut. Raise the front of the vehicle and securely support it on jackstands. Remove the front wheels. Remove the lower engine splash shield. Detach the ABS wheel speed sensor harness and brake hose bracket from the shock absorber. On 2007 and later G35 Sedan models, detach the stabilizer bar link from the control arm. On 2007 and later G35 Sedan models with AWD, remove the front driveaxle and separate the upper control arm from the steering knuckle. Remove the lower mounting fasteners attaching the shock absorber to the lower control arm. Mark the relationship of the shock absorber to the shock tower. Remove the upper mounting fasteners and then remove the shock absorber assembly. On 350Z models, remove the shock tower bar to access the upper mounting fasteners.

To replace the rear shock absorber, first loosen the wheel lug nuts, raise the rear of the vehicle and support it securely on jackstands placed under the frame rails. Then remove the wheel. Raise the lower spring link with a floor jack to relieve the coil spring tension and remove the nuts that attach the upper end of the shock absorber to the chassis and the bolt that attaches the lower end of the shock to the spring link. Installation is the reverse of removal, but make sure to raise the lower spring link with a floor jack to simulate normal ride height before tightening the lower shock absorber mounting fastener.