Disconnect the two clips and pop off the door trim panel and the plastic watershield. Then, remove the window assembly so that it can stay in the top position is required; it can be fixed in place with heavy tape. Pull the electrical connector clip back and remove it at the Window Regulator motor. Then, you should unbolt the door module panel and then pop the panel out, in doing this, you will also need to pull on the window motor connector and unplug it. Subsequently, the fastenings holding the Window Regulator to the door module panel should be unscrewed then the regulator should be withdrawn. For installation reverse the process as followed above but, light grease should be applied on all moving parts. Perform other steps of the initialization where necessary.