For 2003 and earlier models, start by disconnecting the cable from the negative terminal of the battery and pulling the parking brake on. Carefully pry up the plastic trim panel surrounding the shift lever, which is retained by clips. Next, remove the console mounting screws located at the front and rear of the console, then unplug any electrical connections and take out the console assembly from the vehicle, with installation being the reverse of removal. For 2004 and later models, begin by removing the rear seats, followed by the four screws securing the front-to-rear-seat pass-through unit, and then remove the unit. Free the console's lower side covers from their clips and take them off, then remove the rear console lid and cupholder. Detach the switch trim plate from its clips along with the switches, disconnecting the switch electrical connectors. Remove the rear console tray screws from below, lift out the tray, unplug its electrical connectors, and take out the rear console lamp if equipped. Finally, remove the console mounting screws and lift it off the floor. If working on a four-door model, first remove the rear console as previously described, then take out the glove compartment, instrument panel lower covers, and cluster lid. Remove the shift knob and the shift lever trim panel, lift the parking brake lever, and take off its trim panel from the console. Remove the console mounting screws, slide both front seats forward, and lift the console out, with installation being the reverse of the removal steps.