Genuine Nissan Rogue Fuel Tank

Nissan Rogue Fuel Tank Parts Questions & Answers

• Fuel Tank Assembly
  17202-4BA0A
  Q: How to remove and install a fuel tank?

  A: The following procedure is much easier to perform if the fuel tank is empty. Drain the fuel into an approved fuel container using a commercially available siphoning kit (NEVER start the siphoning action by mouth) or wait until the fuel tank is nearly empty, if possible. Remove the fuel tank filler cap to relieve fuel tank pressure. Relieve the fuel system pressure. Disconnect the cable from the negative terminal of the battery. Disconnect the lines and wiring from the Fuel Pump module at the top of the fuel tank. If desired, the fuel pump module can be removed at this time. Raise the vehicle and place it securely on jackstands. If there is still fuel in the tank, siphon it out from the fuel feed line. Remember - NEVER start the siphoning action by mouth! Use a siphoning kit, which can be purchased at most auto parts stores. Remove the exhaust pipe and muffler assembly. Remove the fuel tank heat shield mounting nuts and heat shield. Disconnect the hoses and electrical connector from the fuel tank. On AWD models, remove the rear driveshaft. On 2014 and earlier Rogue models/2014 and 2015 Rogue Select models, remove the rear subframe. Disconnect the parking brake cables from their brackets. Move the cables aside and secure them in place with wire. Loosen the fuel filler hose clamp and remove the fuel filler hose from the fuel tank. Also disconnect the vent and EVAP hoses. Support the fuel tank with a floor jack. Position a wood plank between the jack head and the fuel tank to protect the tank. Remove the fuel tank strap bolts. Remove the tank from the vehicle. Installation is the reverse of removal. Reconnect the battery and perform the necessary re-learn procedures.