To replace the front wheel first free the lug nuts, then lift the front end of the car and support it with jack stands, then you can take off the wheel. Subsequently, the jam nut needs to be loosened just to check the relative position of the tie-rod end in relation to its threading. To remove the tie-rod end, first take out the nut from the tie-rod end threaded ballstud but do not take out the ballstud completely then use puller and remove the ballstud from the steering knuckle arm. Subsequently, take out the nut and then the tie-rod, then unscrew it from the tie-rod end. For installations, the threaded part should be passed through the marked position and the untwisted end of the tie-rod stud should fit into the steering knuckle arm and the jam nut should then be tightened. Place the nut on the ballstud and torque it to the given specification on torque. Last of all, fix the wheel and the lug nuts, then lower the vehicle and tighten the lug nuts to the recommended torque, finally Aligning the wheel if required.