Nissan 14055-BV80C Hose-Water

You can Select Your Vehicle to check if 14055-BV80C fits your vehicle.

The number, routing, and pattern of hoses will vary according to the model, but the same basic procedure applies. Before starting the work, ensure that the new hoses are readily available, along with new hose clips if needed. It is recommended to replace the hose clips when replacing the hoses. Begin by draining the cooling system and saving the coolant if it can be reused. Apply some penetrating oil to corroded hose clips. Release the hose clips from the hose by turning the screw anti-clockwise for worm-drive clips, squeezing the tangs together for spring clips, or cutting off the 'sardine-can' clip. Unclip any wires, cables, or other hoses attached to the hose being removed and make notes for reference if necessary. Remove the hose from its stubs with a twisting motion, being careful not to damage delicate components. If the hose is stuck, it may need to be cut off using a sharp knife, taking care not to damage the stubs. Before fitting the new hose, lubricate the stubs with washing-up liquid or a suitable rubber lubricant. Avoid using oil or grease as they may harm the rubber. Fit the hose clips over the ends of the hose and then fit the hose over its stubs. Work the hose into position and tighten the hose clips. Refill the cooling system, run the engine, and check for any leaks. After a few hundred miles, recheck the tightness of the hose clips on any new hoses. Finally, top up the coolant level if necessary.