Nissan 80502-8Z400 Front Passenger Side Door Lock Actuators

To remove the outside handle, disconnect the control link rod from the outside handle. Then, remove the outside handle retention nuts and pull the handle from the door. On front doors, the outside handle retaining nuts can be accessed through the holes in the door frame. On vehicles with rear doors, pry out the trim caps to access the outside handle retaining nuts. The installation process is the reverse of removal.

They should be lubricated with a thin coat of grease.

A few drops of light oil or lock lubricant.

First, detach the electrical connector from the lock cylinder, if your vehicle is equipped with one. Then, using a screwdriver or a pair of pliers, pry the lock cylinder retaining clip off the lock. Pull the lock outward to disengage it from the door and the lock cylinder control rod. On some models, you may also need to disengage the clip securing the control rod to the lock cylinder.

They should be lubricated with spray-on graphite lubricant.

Once every 3000 miles or every three months.