Nissan 27220-0B025 Motor W/FAN

You can Select Your Vehicle to check if 27220-0B025 fits your vehicle.

Disconnect the negative battery cable. Open the glove compartment and remove it. Disconnect the blower motor electrical connector from the motor, remove the blower motor mounting screws, and pull the blower motor carefully out of the housing. If the blower motor is being replaced, the fan wheel should be transferred to the new motor at this time. It is attached to the blower motor shaft with a push nut. Grasp the nut with pliers and pull it off or pry it off with a small screwdriver, being careful not to crack the push nut. To reinstall the nut, simply push it onto the shaft. The remainder of the installation is the reverse of removal. Some models have an auxiliary heater/air conditioning system located in the rear of the vehicle, behind the left-rear interior trim panel. With the access panel pried out of the trim panel, there is access to remove/test the auxiliary blower motor. The rear blower motor and resistor can be checked in the same manner as the front system. The standard front heater/air conditioning control panel has a separate control knob for the rear system.

The front blower motor resistor assembly is located on the evaporator housing under the right side of the dashboard.