Nissan 31935-1XF01 Sensor Assembly-Revolution

To replace the transmission speed sensors, first disconnect the electrical connector from the sensor. Then, remove the mounting bolt and remove the sensor, discarding the O-ring.

The paragraph discusses two types of transaxles: 2013 and earlier models (including 2014 and later Rogue Select models) use two speed sensors - primary and secondary. In contrast, 2014 and later models (excluding Rogue Select models) use three speed sensors - input speed, primary speed, and output speed sensors.

CVT transaxles have three speed sensors: primary, secondary, and output. The primary sensor is on the outboard side, facing the left wheel. The secondary sensor is at the rear, facing the firewall, and the output sensor is at the rear, facing the left wheel. To replace these sensors, you should loosen the left front wheel lug nuts, raise the vehicle, remove the left front wheel, remove the left fender inner fender splash shield, disconnect the sensor electrical connector, remove the mounting bolt, and remove the sensor. Don't forget to discard the old O-ring and apply transmission fluid to the new O-ring during installation.