Nissan 18201-9Z422 Wire-Accelerator

To adjust the accelerator cable, perform the following steps: Remove Slack: Lift up on the cable to remove any slack. Start Moving Throttle Lever: Turn the adjusting nut until the throttle lever just starts to move. Back Off Adjusting Nut: Back off the adjusting nut 1-1/2 to 2 turns. Tighten Locknut: Tighten the locknut to secure the adjusting nut in place. Check Throttle Valve Movement: Verify that the throttle valve opens fully when you depress the accelerator pedal to the floor and that it returns to the idle position when you release the accelerator.

After detaching the cable casing from the bracket, the next steps involve draining the transmission fluid, removing the fluid pan, and detaching the TV cable from its lever. Remove the bolt and detach the cable from the transmission. Finally, detach the cable adjuster from its bracket and remove the cable.