Nissan 18201-2Y900 Wire Assy-Accelerator

You can Select Your Vehicle to check if 18201-2Y900 fits your vehicle.

The adjustment procedure for the accelerator cable and the cruise control cable is similar, except where noted below. To remove, detach the accelerator cable and the cruise control cable (if equipped) from the throttle lever by rotating the throttle lever until the slot in the throttle lever aligns with the cable, then pass the cable through the slot. Loosen the cable locknut and adjusting nut, then separate the accelerator cable from the cable bracket. From inside the passenger compartment, pull the cable end out from the accelerator pedal arm, then pass the cable through the slot in the arm. Remove the bolts securing the accelerator cable to the firewall. Disconnect any remaining cable clips and remove the cable through the firewall from the engine compartment side. To install, reverse the removal process. Be sure the cable is routed correctly and fasten all the cable retaining clips. If necessary, at the engine compartment side of the firewall, apply sealant to the accelerator cable bracket where it mates to the firewall to prevent water from entering the passenger compartment. To adjust the accelerator cable, lift up on the cable to remove any slack. Turn the adjusting nut until the throttle lever just starts to move. Back off the adjusting nut 1-1/2 to 2 turns. Tighten the locknut. Verify that the throttle valve opens all the way when you depress the accelerator pedal to the floor and that it returns to the idle position when you release the accelerator. Verify that the cable operates smoothly. It must not bind or stick. To adjust the cruise control cable, check the accelerator cable for proper adjustment. Turn the adjusting nut until the throttle lever just starts to move. Back off the adjusting nut 1/2 to 1 turn. Tighten the locknut and check for proper operation of the cruise control system in the passenger compartment.