It is recommended that before any light unit is removed, one should remove the battery negative terminal and reattach it after the fitting of the light. To actually remove the headlight simply unfasten the front bumper, then, you will have to unscrew the two upper securing bolts and the two lower mounting bolts. It is necessary to pull out the headlight unit as it requires disconnection of the wiring connectors, although refitting is the reverse of removal; after the installation, it is recommended to adjust the headlight beam. The front sidelight unit is combined with the combination light unit and is not replaceable, the indicator unit is connected with the headlight unit. In order to solely remove the combination light, you will need to take off the front bumper, or at least a part of it, the combination light's mounting nut has to be loosened, as well as the two bolts; after that the unit has to be pulled out and the wiring connectors have to be disassembled. Front foglight involves removing the inner wheel arch liner, disconnecting the wiring connector from the bulb holder, undoing the two securing bolts that allow for the pulling off of the light unit from the rear of the bumper and to refit, the processes are reversed. Rear light and number plate light is one of the bulbs which require renewal and the procedure applied during the renewal. Rear fog light : Firstly to remove the rear fog light unscrew the rear bumper, next undo the two nuts of the light unit and take out the light unit and for refitting screw in the two nuts of the light unit and screw the rear bumper. Removing the high-level stop-light require pulling the upper part of the blanking strip off the top of the tailgate, two nuts have to be undone to free the stop-light, the unit has to be withdrawn while disconnecting the wiring connector and the procedure for refitting is similar to that of removal.