To replace the front parking and turn signal lights, remove the grille, turn the bulb socket counterclockwise to pull it out, and then remove the bulb from the holder before reversing the process for installation. For the front side marker lights, detach the rubber fender shield, turn the bulb socket counterclockwise, remove the bulb, and reinstall in reverse order. For the rear turn signal and side marker lights, open the liftgate, remove the taillight trim panel, take out the taillight assembly, twist the bulb holder counterclockwise to remove the bulb, and reinstall in reverse order. For fog lights, detach the plastic inner fender liner, disconnect the electrical connector, turn the bulb holder counterclockwise to remove the bulb, and reinstall in reverse order. For the license plate light, remove the liftgate trim panel, twist the bulb socket counterclockwise to pull it out, remove the bulb, and reinstall in reverse order. The high-mounted stop light uses LEDs and requires the entire unit to be replaced if it doesn't light; pry off the access panel, disconnect the wiring, and remove the mounting nuts before reinstalling in reverse order. For back-up lights, remove the liftgate trim panel, take out the mounting nuts and clip, pull the housing out, turn the bulb holder counterclockwise to remove the bulb, and reinstall in reverse order. Interior lights are replaced by prying off the lens, pulling the bulb straight out, replacing it, and snapping the lens back in place; for the trunk light, release the tab on the lens to pivot it open for bulb replacement.
Instrument Cluster illumination issues require replacing the entire cluster if any individual components fail.