How to replace a canister-type fuel filter on Nissan Quest?

Many models have a canister filter that is clip mounted on the firewall below the brake fluid reservoir. Some models have it underneath the vehicle and held with a clamp. Fuel system must be depressurized first, and then the cable has to be disconnected from the battery negative terminal. Detach filter from bracket, loosen screw clamps, detach hoses from top and bottom of fuel filter, and remove filter . A majority of models mount fuel filters in clips on the firewall - just pull them off to gain access to fuel lines. If located beneath vehicle, separate hoses from the filter and then loosen nuts to remove filter from bracket (pay attention to direction of installation). The filter orients itself naturally with inlet and outlet pipes ending at opposite sides which are clearly labeled. Make sure that you install your new filter correctly so that it faces in right direction. On firewall mounted filters, when installed correctly, there should be outlet pipe facing up and inlet pipe facing down. For filters mounted under the car, the outlet pipe should face forward while the inlet pipe should point towards rear of vehicle. It is a complete opposite for installation. Securely tighten screw clamps as well as install inlet and outlet fittings again. Connect battery cable; start engine & check for oil leaks.

Genuine Nissan Quest Fuel Filter

Gas Filter

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

6 Fuel Filters found

View related parts
Nissan Quest STRAINER Fuel
Part Number: 16400-0W005
$26.88 MSRP: $38.93
You Save: $12.05 (31%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Strainer Assy-Fuel; Fuel Filter
- Replaces: 16400-0W010, 16400-3S500, 16400-0W01A
- Warranty: This genuine part is guaranteed by Nissan's factory warranty.
Fits the following Vehicles:
- 2000-2003 Nissan Quest | GXE, SE | 6 Cyl 3.3L | VG33E
View related parts
Nissan Quest Filter-Fuel Tank
Part Number: 17275-7B001
Product Specifications
- Other Name: Filter
- Warranty: This genuine part is guaranteed by Nissan's factory warranty.
Fits the following Vehicles:
- 1999-2003 Nissan Quest | GXE, SE | 6 Cyl 3.3L | VG33E
View related parts
Nissan Quest STRAINER ASY (Fuel For Gas)
Part Number: 16400-0B001
Product Specifications
- Other Name: Strainer Assy-Fuel; Fuel Filter
- Replaces: 16400-0B000
- Warranty: This genuine part is guaranteed by Nissan's factory warranty.
Fits the following Vehicles:
- 1993-1998 Nissan Quest | GXE, XE | 6 Cyl 3.0L | VG30E
View related parts
Nissan Quest STRAINER ASY (Fuel For Gas)
Part Number: 16400-0B000
Product Specifications
- Other Name: Strainer Assy-Fuel
- Replaced by: 16400-0B001
- Warranty: This genuine part is guaranteed by Nissan's factory warranty.
Fits the following Vehicles:
- 1993-1994 Nissan Quest | GXE, XE | 6 Cyl 3.0L | VG30E
View related parts
Nissan Quest Filter-Fuel Tank
Part Number: 17275-0B000
Product Specifications
- Other Name: Filter
- Warranty: This genuine part is guaranteed by Nissan's factory warranty.
Fits the following Vehicles:
- 1993-1998 Nissan Quest | GXE, XE | 6 Cyl 3.0L | VG30E
View related parts
Nissan Quest STRAINER Fuel
Part Number: 16400-7B010
Product Specifications
- Other Name: Strainer Assy-Fuel; Fuel Filter
- Replaces: 16400-7B000
- Warranty: This genuine part is guaranteed by Nissan's factory warranty.
Fits the following Vehicles:
- 1997-2001 Nissan Quest | GXE, SE, XE | 6 Cyl 3.0L, 6 Cyl 3.3L | VG30E, VG33E

Nissan Quest Fuel Filter

The Fuel Filter in your Nissan Quest cleans the gasoline before it reaches more important parts of your engine. In the process, it filters out dirt, rust particles, and water that can cause abrasion on pumps and clog other injectors. The dedicated Fuel Filter located in the fuel line contains a pleated paper cartridge that traps dirt and debris but allows clean fuel to flow. A preliminary in-tank strainer blocks out any major contaminants, while the Fuel Filter is the final line of defense that inhibits small debris from interfering with the system. When the filter media becomes saturated, restricted flow may cause hard starting, rough idle, stalling, or sluggish acceleration, which is an indication it is due for replacement at the specified service interval. In electronic fuel-injected layouts of Nissan Quest vehicles, the Fuel Filter is often in-line between the tank and engine and secured with threaded or quick-disconnect fittings. Fittings seal with O-rings. The Nissan Quest Fuel Filter will ensure constant power delivery and protect the longevity of your fuel system, helping to preserve overall Nissan Quest drivability in everyday use by Nissan owners.

If you need any OEM Nissan Quest Fuel Filter, feel free to choose them out of our huge selection of genuine Nissan Quest Fuel Filter. All our parts are offered at unbeatable prices and are supported by the manufacturer's warranty. In addition, we offer quick shipping to have your parts delivered to your door step in a matter of days.

Nissan Quest Fuel Filter Parts Questions & Experts Answers

STRAINER Fuel
16400-0W005
Q: How to replace a canister-type fuel filter on Nissan Quest?
A:
Many models have a canister filter that is clip mounted on the firewall below the brake fluid reservoir. Some models have it underneath the vehicle and held with a clamp. Fuel system must be depressurized first, and then the cable has to be disconnected from the battery negative terminal. Detach filter from bracket, loosen screw clamps, detach hoses from top and bottom of fuel filter, and remove filter . A majority of models mount fuel filters in clips on the firewall - just pull them off to gain access to fuel lines. If located beneath vehicle, separate hoses from the filter and then loosen nuts to remove filter from bracket (pay attention to direction of installation). The filter orients itself naturally with inlet and outlet pipes ending at opposite sides which are clearly labeled. Make sure that you install your new filter correctly so that it faces in right direction. On firewall mounted filters, when installed correctly, there should be outlet pipe facing up and inlet pipe facing down. For filters mounted under the car, the outlet pipe should face forward while the inlet pipe should point towards rear of vehicle. It is a complete opposite for installation. Securely tighten screw clamps as well as install inlet and outlet fittings again. Connect battery cable; start engine & check for oil leaks.