Loosen the driveaxle/hub nut, then loosen the front wheel lug nuts, raise the front of the vehicle, and support it securely on jackstands before removing the wheel. Next, remove the brake disc and the driveaxle/hub nut. Take out the hub/bearing assembly mounting bolts from the rear of the
Steering Knuckle and remove the hub/bearing assembly from the steering knuckle, supporting the driveaxle with a length of wire to prevent overextension of the inner CV joint. If the driveaxle splines stick in the hub, use a two jaw puller to push the driveaxle out. For installation, reverse the removal process and tighten all fasteners to the proper torque values. For the rear, loosen the rear wheel lug nuts, raise the rear of the vehicle, and support it securely on jackstands before removing the wheel. If equipped, remove the wheel speed sensor and then remove the brake shoes or brake disc as applicable. If the brake backing plate needs to be removed, disconnect the parking brake cable from the backing plate and the brake line from the wheel cylinder. Remove the hub and bearing assembly mounting bolts and then take out the hub and bearing assembly. For installation, reverse the removal process and tighten all fasteners to the proper torque values.