Nissan 40202-JG01A Hub Assembly Road Wheel

Loosen the driveaxle/hub nut, then loosen the front wheel lug nuts, raise the front of the vehicle, and support it securely on jackstands before removing the wheel. Next, remove the brake disc and the driveaxle/hub nut. Take out the hub/bearing assembly mounting bolts from the rear of the steering knuckle and remove the hub/bearing assembly from the steering knuckle, supporting the driveaxle with a length of wire to prevent overextension of the inner CV joint. If the driveaxle splines stick in the hub, use a two jaw puller to push the driveaxle out. For installation, reverse the removal process and tighten all fasteners to the proper torque values. For the rear, loosen the rear wheel lug nuts, raise the rear of the vehicle, and support it securely on jackstands before removing the wheel. If equipped, remove the wheel speed sensor and then remove the brake shoes or brake disc as applicable. If the brake backing plate needs to be removed, disconnect the parking brake cable from the backing plate and the brake line from the wheel cylinder. Remove the hub and bearing assembly mounting bolts and then take out the hub and bearing assembly. For installation, reverse the removal process and tighten all fasteners to the proper torque values.

Loosen the driveaxle/hub nut, then loosen the front wheel lug nuts, raise the front of the vehicle, and support it securely on jackstands before removing the wheel. Next, remove the brake disc and the driveaxle/hub nut. Separate the control arm balljoint from the steering knuckle and detach the tie-rod end from the steering knuckle. Pull the steering knuckle outward and detach the driveaxle from the hub, supporting it with a length of wire to prevent overextension of the inner CV joint. Remove the hub/bearing assembly mounting bolts from the rear of the steering knuckle and take out the hub/bearing assembly. If the driveaxle splines stick in the hub, push the driveaxle out with a two-jaw puller. For installation, reverse the removal process and tighten all fasteners to the proper torque values. For the rear, loosen the rear wheel lug nuts, raise the rear of the vehicle, and support it securely on jackstands before removing the wheel. Remove the wheel speed sensor and the brake disc. On AWD models, loosen the rear driveaxle hub nut, then remove the hub and bearing assembly mounting bolts. Take out the hub and bearing assembly, and if the driveaxle splines stick in the hub, use a puller to push the driveaxle from the hub as the hub and bearing assembly is removed from the trailing arm. For installation, reverse the removal process and tighten all fasteners to the proper torque values.