Nissan 56210-CA025 Rear Shock Absorber Kit

Unfasten the rear wheel lug nuts and lift the rear part of your car and securely place jackstands under the car while turning the steering wheel to lock and preventing the car from moving. Lift the wheel and then put a floor jack underneath the coil spring pocket in order to support the lower rear suspension arm until the block is in place, and the shock absorber is back in its proper place. Pull the tab on the bottom of the link which connects to the stabilizer bar to release it and then remove the nuts over the top of the rear shock absorber which mount this. Subsequently, acquire and loosen the lower mounting bolt and pull out the removal of the shock absorber. Regarding installation, one should reverse the above procedure and finally, after removing the jack, slightly lift the lower suspension arm before tightening the mounting fasteners to the stated torque. Last of all, put the wheel back on, lower the car and fasten the lugs to the recommended torque.

Inspect the bearing for smooth operation and check the rubber for any signs of deterioration.