Nissan 37126-7S026 Journal Kit-Prop Shaft

You can Select Your Vehicle to check if 37126-7S026 fits your vehicle.

In single-piece rear driveshafts, a splined yoke at the front connects to the transmission or transfer case, while the rear section has a splined yoke that joins the front portion, allowing for movement due to suspension changes. Two-piece rear driveshaft models incorporate a center support bearing attached to a frame crossmember. The 4WD front driveshaft includes a slip joint to accommodate suspension movement.

First, remove the driveshaft. Then, place the driveshaft on a bench equipped with a vise. To remove the universal joint, use a small pair of pliers to remove the snap-rings.

First, remove the driveshaft. Then, place the driveshaft on a bench equipped with a vise. To remove the universal joint, use a small pair of pliers to remove the snap-rings.

Maintenance of the driveshaft is typically minimal, with lifelong lubricated universal joints that require replacement if issues arise, necessitating the removal of the driveshaft for servicing.