Nissan 49110-AM600 Power Steering Pump Assembly

Pull the cable from the negative battery clamp. Squeeze fluid from the power steering fluid reservoir with a big syringe or vacuum gun until the tank is empty. Remove the air filter housing. Remove the drivebelt. Remove the cooling fans. Place a drain pan under the pump, then detach first the pressure line and then the supply hose. Seal up the tool connections to block extra fluid waste and keep dust from getting inside. Open the screws holding the power steering pump on, using the accessible holes in the pump pulley. Put the power steering pump on a soft surface and pull it out of its mount, all while keeping fluid from dripping onto your vehicle's painted finish. You need to redo what you did during removal, making sure all bolts stay tight. Replace the old copper gaskets on the pressure lines, put the right power steering fluid into the reservoir, and remove all air from the system. Re-check the power steering fluid level.