Nissan 39241-7Y025 Repair Kit-Dust Boot, Outer

1. Slide the new outer boot and small clamp onto the drive axle, wrapping the splines with tape. 2. Install the inner race retainer ring. 3. Pack the CV joint with grease through the splined hole in the inner race. 4. Tap the outer CV joint into place with a hammer and wood block. 5. Slide the boot into position, add the remainder of the grease, and adjust the length. 6. Equalize the pressure inside the boot and install the new clamps. 7. Install the drive axle (see Section 11).

To check the shock absorbers, park the vehicle on level ground, turn off the engine, and set the parking brake while checking tire pressures. Push down on one corner of the vehicle and release it; it should stop moving and return to a level position within one or two bounces. If it continues to move or fails to return, the shock absorber may be worn. Repeat this check at the other corners.